6
Installation instructions & user manual
806143UK V1.00 July 2019 - HydroChill HC45
Technical support
Tel: 0345 6 005 005 Email: [email protected] www.zipwater.co.uk
Before installation
Before installation ensure that the following have been provided at the
installation site
• Review of all the technical specifications.
• Ensure the under counter cupboard floor can support the product weight when
full of water (allow an extra 3.6kg when full).
• Sufficient space in the cupboard to install the Command Centre and other
components in accordance with these installation instructions. See Technical
specification, page 4 for dimensions.
• For Zip HydroChill HC45 models, 1 x 220-240V AC 13A socket will be required.
• The Command Centre must be installed in accordance with IEE regulations, See
Technical specification, page 4 for power ratings.
Note
Check all cable and hose lengths against inlet /outlet positions before
proceeding (see section 5 & 6 for general layout).
• A wholesome water supply connection with a minimum working pressure of: (see
page 4 min. / max. water supply pressure) with isolating valve inside the cupboard
within reach of the braided hoses and positioned so that the connection point
and the stop cock will not be obstructed when the Command Centre is installed.
• If pressure is likely to exceed 0.7 MPa (7 bar), install a 0.35 MPa (3.5 bar) pressure
limiting valve.
• The appliance must be placed with its base in a horizontal position.
IMPORTANT!
Do not proceed with the installation if these requirements are not met.
!
!
