17
Installation instructions & user manual
806143UK V1.00 July 2019 - HydroChill HC45
Technical support
Tel: 0345 6 005 005 Email: [email protected] www.zipwater.co.uk
Insert filter
Rotate
Insert
Filter replacement
Remove filter
Rotate
Pull
Changing the filter
For safe operation, the filter cartridge should be replaced at least every 6 months, or earlier
if you notice a persistent reduction in water pressure from the tap or an unpleasant taste or
odour in the water.
For safe operation, thoroughly flush the water through after periods of non-use over 12 hours.
Not changing the filters when required may cause the water to become biologically unsafe.
Use only a Zip filter to match the one used in your system product (see Spare parts page 5). The
filter cartridge can be obtained through plumbing suppliers or direct from Zip. The installation
date should be written on the filter cartridge. No special tools or skills are required to install
the filter cartridge.
• Locate the filter in the under-sink cupboard.
• Grasp the filter firmly and twist it horizontally a quarter turn clockwise until it stops.
Some water will drip from the filter head during the replacement process so it is a good
idea to have a bucket and towel handy to catch and mop up any spills.
• Gently ease the cartridge downwards to detach it from the filter head, then pull it out and
discard responsibly. Take care not to tip it up once free as water may spill out.
• Write the date of replacement on the new filter cartridge label.
• Remove the protective plastic cap. The insertion method is the opposite to the removal
method. Align the tabs of the replacement cartridge with the filter head and insert it up into
the filter head.
• Turn the replacement cartridge a quarter turn anti-clockwise until it stops and locks into
position.
• When the filter replacement has been completed purge the system of trapped air by
dispensing water from the tap until it flows without any further spluttering. Run 10 litres of
water through the system to complete the purge.
Air inlet screen
• The HydroChill air inlet screen is located
on the side of the Command Centre.
• The screen needs to be inspected at
least quarterly, cleaned and replaced if
damaged.
• Remove the screen for cleaning by sliding
it forward.
• Rinse off any particles with tap water, then
gently dry with a cloth or towel.
• Slide the screen back into place.
• For best performance the unit should only
be operated with a clean air inlet screen,
correctly fitted in place.
• Maintain at least a 50 mm air gap in front
of the screen at all times.
• Take care not to allow cloths or other
soft materials to accidentally block the air
inlet.
Slide out to remove
