BlackKite, Vehicle Tracking System User Manual
Rev. 1.4.0
Zilogic Systems
Page 34
The field definitions are listed below.
id
indicates which digital output is to be changed, should be in the range
1
to
4
.
state
0
or
1
, the state to change to
Get Digital Input/Output.
The state of the digital inputs and outputs can be obtained using the
following command.
Command
IOGET
Response
OK: DI <id>: <state>, ... DO <id>: <state>
The field definitions are listed below.
id
digital input and digital output index no.
state
0
or
1
, the state of the digital input / digital output
7.5. Configuration Commands
The configuration commands and their meanings are listed below. All configuration variables are
case insensitive. The configuration values are case sensitive.
These commands required admin privileges. These commands are available in all modes.
Saving Configuration Changes.
Configuration parameters modified are not activated, until
saved using the following command.
Command
SAVE
Response
OK: Saved.
GPRS Enable/Disable.
When GPRS is enabled, data is pushed to the server. When GPRS is dis-
abled, data is not pushed to the server. The GPRS enable/disable state can be configured using
the following command.
Command
SET GPRS <state>
Response
OK: GPRS <state>
The current GPRS enable/disable state can be obtained using the following command.
Command
GET GPRS
Response
OK: GPRS <state>
The field definitions are listed below.
state
1
indicates enable,
0
indicate disable.
Access Point Name.
The access point name, username and password, can be configured using
the following command.
Command
SET APN <name>,<username>,<password>
Response
OK: APN <name>,<username>,<password>
The current APN setting can be obtained using the following command.
Command
GET APN
Response
OK: APN <name>,<username>,<password>
Server IP and Port.
The server IP address and port where location and sensor updates are to
be sent, can be configured through the following command.
Command
SET SERVER <ip>,<port>
Response
OK: SERVER <ip>,<port>
