ZiLOG Z8 Encore! XP, Быстрые руководства пользователя

Страница: 9 / 15

Z8 Encore! XP F042A 8-Pin Development Kit
Quick Start Guide
QS005506-0111 Page 9 of 15
1. To run the sample project with the ZDS II debugger enabled, set the jumpers on the de-
velopment board as follows:
– J1 OUT
– J2 IN
– J3 OUT
– J4 IN (must be installed to run in DEBUG mode)
– J5 1-2
– J6 1-2
– J7 IN (must be installed to run in DEBUG mode)
– J8 1-2
– J9 1-2
– J10 1-2
– J11 OUT
2. Connect and apply power to the development board as described in Setting Up the De-
velopment Board on page 3.
Do not apply power to the development board unless the USB Smart
Cable is connected both to the host PC and to the development board’s
DBG port P3.
3. Run the Zilog Developer Studio II software. By default, the Zilog Developer Studio II
program is located in the Start menu under :
Programs

Zilog ZDS II Z8 Encore! <version_number>

ZDS II Z8 Encore!
<version_number>
4. Select
Open Project
from the
File
menu. The
Open Project
dialog box appears.
The sample used in the following steps is in the C programming language.
An assembler version of the
ledBlink
sample is located in the
Z8F04XP_8Pin_ledBlink_asm\src
folder.
Caution:
Note: