Z8 Encore! XP F042A 8-Pin Development Kit
Quick Start Guide
QS005506-0111
Page 7 of 15
2. Click
Next
.
3. Select
Search for a suitable driver for my device (Recommended)
and click
Next
.
4. Select
Specify a location
and click
Next
.
5. Browse to the following driver directory and click
OK
.
<ZDS installation>\device drivers\USB\x32
6. Upon finding the appropriate driver, click
Next
.
7. Click
Finish
to complete the installation.
Connecting the USB Smart Cable to the Target Board
Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable six-
pin DBG connector, as displayed in Figure 2. Attach the free end of the ribbon cable to the
DBG connector on the target board. Ensure that pin 1 on the ribbon cable (indicated by the
dark stripe) is aligned with pin 1 on the target connector (see
Figure 1
on page 3 for the
location of pin 1 on the Z8 Encore! XP 8-pin development board).
Figure 2. Connecting the Six-Conductor Ribbon Cable to the USB Smart Cable
Applying Power to the Development Board
Observe the following steps to apply power to the development board:
1. After installing the USB Smart Cable, connect the power supply to the development
board at connector P1, then to an electrical outlet.
