15
All information contained herein is the exclusive copyright of Round Bank Engineering Ltd and is not to by copied,
duplicated or otherwise distributed without the express permission of Round Bank Engineering Ltd, Unit 7, Victoria
Business Park, Halifax, UK, HX1 5ND - +44 (0) 1422 647177
–
Control Setup TAB
These are the parameters used to set up various applications.
For Parameters (variables that are stored in non-
volatile EEPROM Memory) each Box has a “G” and
an
“S” button. The “G” butto
n is for GET parameter from the controller (this will read the value
stored on the controller and display this in the adjacent box). T
he “S” is the SET parameter in the
controller (this will set the parameter that is in the adjacent box to the controller).
More information regarding each parameter can be found in the “
Command &
Parameter Details”
section of this document.
Data Item
Reads various variables
within the Drive Module.
Fault Code
Reads the Drive Fault
Code if something has
gone wrong.
Fault Data
Reads the data of the
fault.
Reset Fault
Resets the fault code.
Invert Settings
Changes Polarity of the Inputs
Start Delay
Delays the time between
powering up and motor
starting (if Enable input is true)
Analogue Scaler
Scales the Analogue input and
the Pot input.
Fixed Speed (% Duty)
Sets the PWM duty cycle
when no PID is used.
Duty Acc/Dec
Acceleration and Deceleration rates when no PID is used.
Fixed Speed (PID Hz)
Sets the Target Frequency
when the PID is used.
PID Acc/Dec
Acceleration and Deceleration rates when the PID is used.
PID Delay (ms)
Sets the delay between motor
starting and PID switching on.
PID Enable
1 = PID is switched ON, 0 PID is
switched OFF.
Motor Speed (Hz)
Reads the motor speed
Data Export Time (ms)
Sets the timing between data points when exporting. 0 = No
export Data.
PID Data Item
Returns variables within the
PID Module.
Output Setting
Changes function of the
output pin
