ZF MMC-343, Инструкция пользователя

Страница: 5 / 14

MMC-343 Rev - 09/11 Page 7
MMC-343 Rev - 09/11
7 Installation
Before starting the actual installation of the Station Expander, make sure you have the correct parts and
tools. See section 6 Tools For Installation. Read ALL the instructions pertinent to each part before
beginning the installation of that part
7.1 Station Expander
Figure ENG-283-4: Station Expander Dimensions
A Place the Station Expander on the mounting surface and mark the three screw holes.
B Remove the Expander and drill the screw holes.
C Secure the Expander using 1/4 inch or M6 fasteners.
D Connect to the Bonding System.
A Insert the Wire Harness plug into the
POWER
connector on the Station Expander.
B Continue with the following Sections that apply to this application.
NOTE: When connecting the plugs, ensure that the release buttons are depressed and held until plug is
fully connected. To disconnect the plugs, the release buttons MUST be held depressed until plug is
disconnected.
NOTE: When installing the harness cable, support the cables using clamps or straps not more than 18
inches (0,5m) apart, unless contained in a conduit. Install each cable so it is protected from physical
damage. Refer to ABYC Standard E-9.
WARNING: When connecting the Power Harness to the Station Expander be sure the power is OFF.