Page 14
MMC-343 Rev - 09/11
10.3
H1 - Erase EPROM
This Function is used during Adjustments or Troubleshooting.
(For Authorized Personnel Use ONLY)
11
Dock Trials
Ensure 9000 Series / CruiseCommand System has been installed, adjusted, and tested before
performing the following tests for the Station Expander.
11.1
Control Head (Engines Stopped)
A
Turn the power ON to the control system
.
B The Control Head at each station will produce an intermittent tone.
C Take command at a remote station.
D Perform each of the following steps on all Control Heads.
• Move each Control Head lever full Ahead and full Astern. Ensure correct 9000 Series /
CruiseCommand Processor and Station Expander reacts to lever movement.
• Place the Control Head levers in the Neutral detent position.
• Depress and hold the station transfer button.
• Move the Control Head levers to the Ahead detent position before releasing the transfer
button.
• The red indicator light on the Control Head should blink, indicating 9000 Series /
CruiseCommand has been placed in Warm-up Mode. Warm-up Mode only operates in
the Ahead direction.
•
If the red indicator light blinks, continue with Control Head testing
•
If the red indicator light does not blink, check connections as stated in Section 7.5
11.2
Engine Stop Switches Test (Engines Running)
A Start engine(s).
B Verify that all Engine Stop Switches function correctly at all stations.
Refer to information supplied by engine manufacturer or switch supplier for set up and adjustments.
WARNING: Turn OFF the control system power before disconnecting from the batteries. Do not disconnect
battery terminals when engine is operating.
NOTE: This will check that the Control Head is operating. * On Twin Screw or more applications ensure
the Port Control Head lever operates the Port Processor and the Starboard Control Head lever operates the
Starboard Processor, etc. *
CAUTION: An Engine Stop Switch at each station is an absolute requirement. Refer to CFR46, SEC. 62.35-
5 and ABYC P-24.5.8.
WARNING: Do not attempt to continue tests until Engine Stop Switches function correctly.
