ZHD 1500/2000-135/155/175
22
Installation
www.zepro.com
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
6.5
Underrun protection
6.5.1
Installation
Test the position of the underrun protection
without tightening the bolts to check that
the statutory dimensions are obtained.
Adjust if necessary then tighten the bolts
with a torque wrench.
1. Fit the inner part of each bracket at
one of four heights. Select the height
that meets the statutory require-
ments, see section "6.5.2 Statutory
dimensions" on page 23. Use the
corresponding bolts M12x100. As-
semble without tightening the bolts,
see Fig. 26.
2. Fit the outer part of each bracket
at one of five positions. Select a
position that meets the statutory
requirements, see section "6.5.2
Statutory dimensions" on page 23.
Check carefully that there is no
risk of the outer part of each
bracket colliding with any part of
the cylinders when using the lift’s
functions. In particular, check in
relation to the cylinders’ hose
connections, especially when
the outer part of the brackets is
installed a long way in.
m
WARNING!
Use the corresponding bolts M12x80.
Assemble without tightening the bolts.
See Fig. 27.
3. Check that the installation meets the
statutory requirements.
4. Tighten all the bolts using a torque
wrench.
Tightening torque: 80 Nm.
5. Fit the member end caps, rotated so
the logo is the right way up, and press
them firmly to secure. If necessary,
tap carefully with a rubber hammer.
Fig. 26. The inner part of the brackets
can be fitted at one of four heights
Fig. 27. The outer part of the brackets can
be fitted in one of five positions
Fig. 28. Fit the member end caps
Fig. 29. Installing underrun protection
133
193
241
301
617
667
717
767
817
