ZHD 1500/2000-135/155/175
16
Installation
www.zepro.com
6
Installation
Also consult the vehicle manufac-
turer’s body instructions and Zepro’s
instruction booklet before installation.
NOTE.
Zepro tail lifts are only approved for
installation with Zepro installation kits.
m
WARNING!
6.1
Support frame
1. Measure and mark the midpoint of
the rear member of the vehicle. See
Fig. 15.
2. Bolt or spot-weld the mounting jig to
the rear member, so that both mid-
points are aligned. See Fig. 16. Art.
no. 51724 for ZHD 1500/2000
Art. no. 52312 for ZHDL 1500/2000.
3. Position the support frame under the ve-
hicle chassis.
4. Temporarily connect the control card to
enable the lift functions, see section "7
Temporary operation of lift" on page 31.
5. Raise the lift arms to their highest
position.
6. Attach the lift arms to the eye of the jig.
Use the steel platform’s normal bolts.
7. The support frame should be posi-
tioned as high as possible within the
specified C dimension. Adjust the
frame to the ideal height under the
chassis. A workshop jack is useful. The
frame must be positioned parallel with
the floor of the vehicle body and must
not be in contact with the vehicle chas-
sis; there must be a few millimetres of
play. If necessary, adjust the angle of
the arms by carefully operating the lift.
8. Install the brackets on the support
frame so that its opening is facing
towards the front of the vehicle, and
adjust the position of the frame so they
are in contact with the vehicle chassis.
9. Install the U-profile with associated
washers and nuts, but do not tighten
these. Screw on the nuts alternately
until the U-profile is aligned in contact
with the frame, see Fig. 18.
Fig. 15. Measure and mark the midpoint of
the rear member of the vehicle.
Fig. 16. Bolt or spot-weld the
mounting jig to the rear member
Art. no. 51724 for ZHD 1500/2000
Art. no. 52312 for ZHDL 1500/2000.
Fig. 17. Mounting jig,
Fig. 18. Install the U-profile with as-
sociated washers and nuts
