ZHD 1500/2000-135/155/175
Installation
17
www.zepro.com
10. When installing on a frame without pre-
drilled holes, install first with a screw in
the brackets’ slot-shaped holes. On the
vehicle chassis, mark the middle of the
brackets’ slot-shaped holes and then drill
Ø14 mm holes in the frame, see Fig. 20.
11. Bolt the brackets securely on the outside
of the vehicle chassis. Use M14x45 bolts
and install the associated washer and
nut on the inside of the vehicle chassis.
Install the bolts but do not tighten.
12. Check and perform fine adjustment
regarding the position of the lift. Then
tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
13. Using a torque wrench, tighten the
bolts holding the U-profiles.
Tightening
torque: 280 Nm.
14. Drill holes in the vehicle chassis for
mounting bolts, Ø14 mm. Drill in the outer
holes of each bracket. Use M14x45 bolts
and install the associated washer and
nut on the inside of the vehicle chassis.
Installation must be performed with at least
6 bolts in the outer holes. The bolt that
was installed initially in the slot-shaped
hole may not be included in this figure. If
necessary, this bolt can now be moved
to one of the outer holes, see illustration.
Then tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
Welding is not permitted on the
chassis brackets.
Do not move the lift all the way to
the armstops or with the platform
fitted before all the bolts are fully
tightened against the chassis.
Do not place the lift under load until:
· the correct number of bolts
have been installed and torque-
tightened.
· the vehicle body is installed to
reinforce the truck chassis.
NOTE.
15. Remove the mounting jig.
Min. 260
Min. 20
Min. 180
Min. 20
Min. D
D
Min. 6 pcs.
M14x45 10.9
120 Nm
New hole
Fig. 19. The chassis bracket requires
at least 35 mm clearance between ve-
hicle chassis and support frame
Fig. 20. Install the chassis bracket with
at least six M14x45 10.9 bolts
When installing on chassis with pre-
drilled holes, go directly to point 16.
35 mm
