ZHD 1500/2000-135/155/175
18
Installation
www.zepro.com
16. Bolt the brackets securely on the
outside of the vehicle chassis. Install
in the slot-shaped holes with at least 6
screws. Use suitable bolts (durability
equivalent to M14 10.9 or higher) and
install the associated washer and nut
on the inside of the vehicle chassis.
Install the bolts but do not tighten.
See Fig. 21.
17. Check and perform fine adjustment
regarding the position of the lift. Then
tighten the bolts with a torque wrench.
Tightening torque: Standard for
selected screw.
18. Using a torque wrench, tighten
the bolts holding the U-profiles.
Tightening torque: 280 Nm.
19. Drill holes in the vehicle chassis for
mounting bolts in each bracket’s two
upper round holes. Use suitable bolts
(durability equivalent to M14 10.9 or
higher) and install the associated
washer and nut on the inside of the
vehicle chassis. See Fig. 21. Tighten
the bolts with a torque wrench.
Tightening torque: Standard for
selected screw.
Welding is not permitted on the
chassis brackets.
Do not move the lift all the way to
the armstops or with the platform
fitted before all the bolts are fully
tightened against the chassis.
Do not place the lift under load
until:
· the correct number of bolts
have been installed and
torque-tightened.
· the vehicle body is installed
to reinforce the truck chassis.
NOTE.
20. Remove the mounting jig.
When installing on chassis with
pre-drilled holes
Fig. 21. Installing the chassis bracket on ve-
hicle chassis with pre-drilled holes
