Zepro ZDK 250 135, Руководство по установке

Страница: 25 / 66

ZDK 250 135/155 Installation
25 www.zepro.com
Lock screws, 3 pcs.
Out
In
Image 36. Adjusting the fit with the vehicle body
Image 37. Adjusting the tilt angle
4. Turn the adjusting collar so that the platform just
meets the seal on the vehicle body. Image 36.
5. Loosen the three lock screws on the other tilt
cylinder. Image 37.
6. Turn the adjusting collar so that the tilt cylinder
aligns with the attachment on the platform. See
Image 37.
7. Fit the other tilting cylinder to the platform mount-
ing. Use the supplied shaft and support wheel.
IMPORTANT
!
Make sure the cylinder is installed with the grease
nipples facing up.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust the two cylinders alternately so that the plat-
form meets the vehicle body, see Image 36 (B).
10. Tighten the lock screws of the adjusting collar
using a torque wrench Tightening torque: 3-5 Nm.
Image 38. Fitting the tilt cylinder to the platform
IMPORTANT
!
The max. length of both cylinders must be adjusted
equally to avoid unwanted bending forces.