Zepro ZDK 250 135, Руководство по установке

Страница: 21 / 66

ZDK 250 135/155 Installation
21 www.zepro.com
with the frame, see Image 26.
9. When installing on a frame without pre-drilled holes,
install first with a screw in the brackets’ slot-shaped
holes. On the mark the middle of the brackets’ slot-
shaped holes and then drill Ø14 mm. holes in the
frame; see Image 28.
10. Bolt the brackets securely on the outside of the
vehicle chassis. Use M14x45 bolts and install the as-
sociated washer and nut on the inside of the vehicle
chassis. Install the bolts but do not tighten.
11. Check and perform fine adjustment regarding the
position of the lift. Then tighten the bolts with a
torque wrench.
Tightening torque: 120 Nm.
12. Using a torque wrench, tighten the bolts holding the
U-profiles.
Tightening torque: 280 Nm.
13. Drill holes in the vehicle chassis for mounting bolts,
Ø14 mm. Drill in the outer holes of each bracket.
Use M14x45 bolts and install the associated
washer and nut on the inside of the vehicle chas-
sis. Installation must be performed with at least 6
bolts in the outer holes. The bolt that was installed
initially in the slot-shaped hole may not be included
in this figure. If necessary, this bolt can now be
moved to one of the outer holes, see illustration.
Then tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
Min. 260
Min. 20
Min. 180
35 mm
Min. 20
Min. D
D
Min. 6 pcs.
M14x45 10.9
120 Nm
New hole
Image 27. The chassis bracket requires
at least 35 mm clearance between ve-
hicle chassis and support frame
Image 28. Install the chassis bracket
with at least six M14x45 10.9 bolts
When installing on chassis with pre-drilled holes, go
directly to point 16.