Zepro ZDK 250 135, Руководство по установке

Страница: 27 / 66

ZDK 250 135/155 Installation
27 www.zepro.com
2
3
5
4
End stop
Adjusting collar
Lock screw
NOTE!
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see previ-
ous page).
1. Operate lift up so that the platform reaches the
vehicle floor. Image 41.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the plat-
form (3). Image 42.
3. Tilt the platform down to max. 10 degrees below
the horizontal. Image 41.
4. Adjust the end stop all the way to the top of the
cylinder (4). Image 42.
5. Tighten the lock screw in the end stop (5). See il-
lustration. Image 42.
The tightening torque for lock screws is 3-5 Nm
Test all functions.
4.2.2 Adjusting the downward tilt angle
Bolt
Washer
Image 41. The tilt angle must be ad-
justed to max.10° down
Image 42. End stop with lock screw
Image 43. Tilt cylinder
m
WARNING!
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10°
if there are going to be people on the platform. .