Zepro ZDK 250 135, Руководство по установке

Страница: 62 / 66

ZDK 250 135/155
62
Testing and verification
www.zepro.com
11 Testing and verification
Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
11.1 Static load test
11.1.1 Deformation
• Position the tail lift half way to vehicle floor level and with the platform horizontal. Measure
dimensions A-B-C-D for comparison as illustrated.Image 91
• Place a test load on the platform, as shown in table (for each lift model/lift capacity).
• Remove the test load from the platform.
• Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its at-
tachment point.
11.1.2 Operation
• Place a test load on the platform, as shown in the table. The tail lift must be at the same level and angle
as the vehicle floor.
Leave the test load for 15 minutes.
• Verify that platform operation is not more than 15 mm in the vertical direction (points A and D) and not
more than 2° in the angular direction (points B and C), in relation to the vehicle floor level.
11.1.3 Static load (Test load 1.25 x tail lift loading capacity). For tail lifts with a
load centre of 1000 mm.
Capacity Load 1500 kg Load 2000 kg
Distance out on platform (L)
1500 kg 1250 mm -
2000 kg 1625 mm 1250 mm
Image 91. Testing and verification
Max 2º
Max. 15 mm
B
D
C
A
B
D
C
A
Vehicle
floor level
Deformation
Operation