Zepro Z3N 75-100, Инструкция по установке

Страница: 8 / 62

Z3N/Z3NU/Z3NN/Z3NNU/Z3NW/Z3NWU 75-100
8
Safety rules
www.zepro.com
2 Safety rules
2.1 Moving parts -
free movement
min. 40 mm
10º
10º
Image 5. Clearance to the closest part of
the cylinder must be at least 40 mm
Image 6. The platform may not be tilted
down more than 10º from the horizontal
2.2 Connection of third-party equipment is forbidden
m
WARNING!
Connecting third-party equipment (electric or hydraulic) to Zepro tail lifts is forbidden. Connecting third-party equipment could
interfere with the lift’s system and its safety functions. Risk of injury and damage. If it is necessary to install other equipment,
check the vehicle manufacturer’s body instructions and use the attachment features on the vehicle.
2.3 Installation
m
WARNING!
Installation where the platform cannot reach ground level is prohibited.
m
WARNING!
ZEPRO tail lifts are only approved for installation using ZEPRO assembly kits.
IMPORTANT!
All specified tightening torques apply when using torque wrench or screw/nut runner with torque control. Torque spread max ±5%.
m
WARNING!
During final inspection*, the space occupied by the moving
cylinders must be cleared and made safe. There is a risk
of collision between the cylinder and the following items:
subframe, truck chassis, beam for rear light (number plate)
and the chassis bracket of the lift (with a short overhang).
**Final inspection to be carried out with the platform at
the vehicle floor and tilted down 10°. The clearance from
the closest part of the cylinder must be at least 40 mm.
m
WARNING!
The platform may not be tilted down more than 10º from
the horizontal.