Z3N/Z3NU/Z3NN/Z3NNU/Z3NW/Z3NWU 75-100
24
Installation
www.zepro.com
4.3.7
Adjusting the tilt cylinder
The tilting cylinder can be adjusted in order that the
platform fits the respective mounting. For vehicle bod
-
ies without rear doors the platform is adjusted against
the side sealings. For vehicle bodies with rear doors
the platform is adjusted so that it stops in the vertical
position and that there is sufficient space between back
doors and platform.
NOTE!
Before the tilt cylinder is attached to the platform, the
tilt cylinder should be adjusted first.
1. Detach the rubber bellows.
2. Loosen the lock nut (Zepro tool 54598)
Turn push rod clockwise or anti-clockwise depending
on the desired adjustment. See illustration.
Adjustment clockwise, the platform is lowered.
Adjustment anti-clockwise, the platform is lowered.
To ensure that the locking nut is fixed in the set posi
-
tion it is recommended that it is locked with Loctite
243 or equivalent.
NOTE!
Max adjustment distance is 30 mm. Do not exceed this!
3. After adjustment, tighten the locking nut. 80 Nm.
Refit the rubber bellows. Rubber bellows must be fitted
so that they are against locking bolts (see illustration).
4.3.8
Purging the cylinders
For all cylinder models:
Fully lower the platform to the ground a few times to
purge the lift cylinders.
You may have to lift the truck to fully lower the platform
.
Concerning tilt cylinder models:
Tilt cylinders can be purged by closing the platform
against the vehicle body and then opening and tilting
all the way down.
Max 30 mm
+
Art. nr. 54598
Image 33. Body
without rear doors.
With side seals.
Image 34. Body
with rear doors.
Image 35. Loosen the lock nut
Image 36. Use loctite 243 or equivalent
Image 37. M
ax adjustment distance is 30 mm.
Image 38. Rubber bellows must be fit-
ted so that they are against locking bolts
Содержание Z3N 75-100
Страница 2: ......