© 2013/EN Zep Solar, Inc. reserves the right to make specifications changes without any prior notice. All rights reserved.
www.zepsolar.com
Document #800-0329-001 Rev F
File Generated July 3, 2013
Page 8
ZS SPAN INSTALLATION MANUAL FOR RAIL-BASED APPLICATIONS - U.S.
2.3 ZS Span Accessory Components
Array Skirt
End Cap
Grip
Conceals hardware for an aesthetic appearance on all sides of the array, and
also serves as a jig during installation to keep the first row of modules straight.
Also serves as a structural component when attached to modules via the Key
side of a Cam Foot Rockit with Interlocks connectiong sections of Array Skirt.
Listed by UL to UL 2703.
Used to cover the ends of the Array
Skirt on the front row of modules for
a more aesthetic appearance.
Listed by UL to UL 2703.
Used to secure Array Skirt after attaching the
Array Skirt to the first row of Cam Feet.
Listed by UL to UL 2703.
* When properly installed, these Accessory Hardware Components are capable of creating an electrical bond
with adjacent Zep Solar hardware components. See
on page 33 for details.
Outside Corner Cap
Used to bridge the corners when Array
Skirt is applied all around the perime-
ter of the array, for a more aesthetic
appearance.
Listed by UL to UL 2703.
Part No. 850-1421
T-Lock
Attaches the Array Skirt to the module
frame along the non-leading edges of
the array. Creates an electrical bond
between Array Skirt and module.
Listed by UL to UL 2703.
Array Skirt profile view
AC/DC Cable Clip
Snaps into the Zep Groove to secure array
wiring, and to adjust wire tension. Fits a
variety of cable sizes.
Inside Corner Cap
Used to bridge inside corners when
Array Skirt is applied all around the
perimeter of the array, for a more aes-
thetic appearance.
DC Wire Clip
Snaps into the Zep Groove to
secure array wiring, and to adjust
wire tension, with parallel and 90
degree clips. Fits wires 5.2mm-
7.6mm in diameter.