Zennio GetFace IP
http://www.zennio.com
Tecnical Support
:
http://support.zennio.com
20
Note
:
this field is enabled provided that
“Virtual number” has been selected in
Dial by Numeric Keypad (see section 3.2.4.3).
User Phone Numbers
:
Phone Number
: string with the already described format.
Time Profile
: time range in which call reception is allowed.
Parallel call to following number
: if parallel calling to another number is
required (i.e., in case of more than one Z41 COM in the same house), this
checkbox should be enabled.
User Deputy
: user the calls should be redirected to in the event of not
being the current user available. If
Parallel to following deputy
is
enabled, all calls will be transmitted in parallel to both the current user and
the deputy. This option can be useful when there are more than three Z41
COM in the same house.
User activation
: user activation / deactivation code and current status (only
for the ZVP-KEYPAD module).
Access Settings:
(simple by default), which is based on combining an RFID
card along with a code to be typed for the door opening (only for the ZVP-
KEYPAD and ZVP-RF modules). Time profiles are allowed for activation /
deactivation.
User Switch Codes
: user private code for the switch opening. Time profiles
can be established to restrict its application. Only for the ZVP-KEYPAD
module.
User Cards
: ID of the user access card and time profile that will remain
active. One card is allowed per user. Only for the ZVP-RF module.
3.1.4
DOOR OPENING CONFIGURATION (HARDWARE/SWITCHES)
It is possible to configure the opening of electric locks linked to Zennio GetFace IP.
This allows controlling them from Z41 COM (up to three electric lock can be enabled).
For instructions on how to wire the lock system to Zennio GetFace IP please refer to
section 2 and to datasheet of the device.
