MINiBOX 45 v2/MINiBOX 25 v2
Technical Support:
23
➢
Valve
: a short or long press will switch the current status of the relay and
therefore of the valve. The LED will show the state of the relay anytime (on
= relay closed; off = relay open).
Disabled output
: outputs disabled by parameter will not react to button
presses under the Test Off mode.
Regarding the lock, timer, alarm and scene functions, the device will behave under the
Test Off mode as usual. Button presses during this mode are entirely analogous to the
reception of the corresponding orders from the KNX bus.
Test On Mode
After entering the Test On mode, it will only be possible to control the outputs through
the on-board pushbuttons. Orders received through communication objects will be
ignored, with independence of the channel or the output they are addressed to.
Depending on whether the output has been parameterised as an individual output, as
part of a shutter channel or a fan coil block, the reactions to the button presses will differ.
Individual output
: short or long pressing the button will commute the on-off
state of the relay.
Shutter channel
: pressing the button will make the shutter drive move upward
or downward (depending on the button) until the button is released again, thus
ignoring the position of the shutter and the parameterised times.
Note
:
after leaving the Test On mode, the status objects will recover the values
they had prior to entering Test On. As the device is never aware of the actual
position of the shutter (as the shutter drive does not provide any feedback),
these values may not show the real position. This can be solved by performing
a complete move-up or move-down order, or by calibrating the shutter position
in the Test On mode until it matches the status objects.
Fan Coil module
: the behaviour is similar to that of the Test Off mode, although
in this case the three fan speeds are supposed available.
