90
DEUTSCH
FRENCH
91
INSTALLATION ET DéSINSTALLATION
notes pour l'installation
1) Avant l’installation, assurez vous que toutes les connexions sont correctes et que
l'appareil fonctionne normalement. une connexion incorrecte peut endommager
l’appareil.
2) utilisez seulement des accessoires conçus pour cet appareil. l’utilisation d’accessoires
non compatibles peut endommager cet appareil.
3) Avant l’installation, attachez tous les câbles d'alimentation.
4) ne pas installer l’appareil proche d’une source de chaleur pour éviter des dommages
aux composants électriques tels que la tête du laser.
5) installer l'unité horizontalement. installant l'unité plus de 30 degrés verticalement
peuvent avoir comme conséquence une plus mauvaise performance.
6) Pour éviter toute étincelle électrique, branchez d'abord le pôle positif et en suite le pôle
négatif de la batterie.
7) n’obstruez pas la sortie du ventilateur de refroidissement pour assurer une dissipation
thermique suffisante, pour éviter d’endommager l’appareil.
installation de l’appareil
méthode A
(1) insérez le support de montage dans le tableau de bord, avec un tournevis pliez les
pattes de fixation pour maintenir le support en place.
(2) utilisez 2 vis m5x5 à tête conique pour fixer les deux pattes d’assemblage de chaque
cote de l’appareil. (Voir l'illustration 1)
(illustration 1)
(3) Vissez 1 vis de m5x 24 dans le trou derrière l’appareil et mettez la gaine en caoutchouc
par-dessus la vis. (Voir l'illustration 2)
Pattes d'
assemblage
INSTALLATION ET DéSINSTALLATION
(4) insérez l'appareil dans le support de montage, vissez les 4 vis m2x2 pour fixer l’appareil
au support de montage.
note :
■
Selon la profondeur de l'ouverture du tableau de bord, utilisez des longueurs de pattes
d’assemblage différentes. Si l'ouverture du tableau de bord n’est pas assez profonde,
l’appareil peut être avancé jusque à 10mm.
méthode B
(1) insérez cet appareil directement dans l'ouverture du tableau de bord.
(2) Fixes les supports de chaque cote de l’appareil avec les vis m4x 3, m5x 5 ou m5x5 a
tête conique.
gaine en caoutchouc
Support de montage
Supports
Tableau
de bord
(illustration 2)
Tableau
de bord
Pattes d' assemblage