11
3
4
C
J
A
Using the supplied 4mm Allan Wrench included, insert four M6x14 Machine Screws
through the holes in each Crossbar End going into the Leg and rotate each screw just a
few turns. Do not fully tighten until later.
Flip the assembly over to gain access to all four M6x14 Machine Screws.
ASSEMBLY
SETUP INSTRUCTIONS
ZEN STAND UP DESK
Prop up one of the assemblies from Step 3 as shown. Insert four Machine Screws
through the four holes of the Side Bracket going into the Crossbar End / Leg Assembly.
Using the hex key included, rotate each screw just a few turns, starting with the two
outside screws.
Now repeat step 3 and 4 with the other assembly. Tighten all screws from step 3 and 4
only once the four Side Bracket screws have been fully tightened.
C
J
E
A