20
3. Within 2 seconds of releasing, press and hold the M button for about 5 seconds until the
LED displays and flashes the lowest height setting. Note: If the display returns to RST before
the next step you will need to repeat this step.
4. To change the value of the lowest height:
PROGRAMMING THE
SYSTEM
Once the new value is displayed, wait about 5 seconds for the display to return to RST.
Complete the reset process by pressing and holding the DOWN button again until your desk
lowers slightly, then raises and displays your new lower height.
Setting One Touch or Constant Touch
Depending on where you use your Zen Space Desk, and in accordance with specific
occupational health and safety requirements, you may need to change your desk to Constant
touch from One Touch which is standard. Constant Touch still allows you to program memory
presents, however requires you to hold your desired number preset down the entire
movement, where as One Touch only requires you to push the button and let go.
To switch between One Touch and Constant Touch:
1. Press the DOWN button on the Keypad until the desk reaches its lowest position, then
release for 2 seconds.
2. Press and hold the 1 button for about 5 seconds while the LED flashes RST and then
switches to either:
• 10.1 = One Touch
• 12.2 = Constant Touch
3. Your desk will display its current setting (standard is 10.1), then return to RST. To change
you will need to reset the desk, then repeat steps 1 and 2 to change the settings to Constant
Touch.
Your new programming is now saved.