Zelmer ZVC431, Руководство пользователя

Страница: 47 / 56

47
ZVC431-001_v01
9 Handgrip for carrying the vacuum cleaner
10 CYKLON dust container bracket
11 Bolt – a mechanic controller of suction power
12 Accessory compartment
13 Suction hose
14 Telescopic pipe
15 Outlet filter HEPA H13 (installed in the vacuum cleaner)
16 Inlet filter (installed in the CYKLON dust container)
A HEPA H13 (ZVC431HP)
B EPA E10 (ZVC431SK)
17 Foam inlet filter (installed in the CYKLON dust container)
18 CYKLON dust container (a removable part of the vacuum
cleaner)
19 Switch-over nozzle brush
20 Crevice nozzle
21 Small brush
22
Small nozzle
23 BNB (Brush Natural Bristle) floor brush (ZCV431HP)
Is used to clean and polish hard, scratch sensitive
surfaces such as wooden floors, floor panels, parquet,
marble, tiles, etc.
Delicate and soft natural bristles ensure maximum
vacuum effectiveness and protects against scratching
the cleaned surface.
Before first use
B
1
Put the end of the suction hose to the inlet of the vacuum
cleaner. A characteristic “click” signalizes the hose has been
properly installed.
2
Connect the other end of the hose with the telescopic
suction pipe.
3 Select the needed length of the telescopic suction pipe
by sliding the slider according to the arrow, and pulling out/in
the pipe.
4 Install a nozzle or a brush on the other end of the suction
pipe.
Technical parameters
The type of the vacuum cleaner and the technical parameters
are indicated on the rating label. Mains protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing the Directive
of the European Parliament and of the Council 2009/125/EC
with regard to eco-design requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament and of
the Council 2010/30/EU with regard to energy labelling of
vacuum cleaners.
Noise level: 78 dB(A).
Static electricity
In the process of vacuuming of some surfaces in areas of
low air humidity the device may become electrically charged.
It is a natural phenomenon – it does not damage the device,
and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend you to:
●
discharge the device by touching metal items in the room
with the pipe,
●
increase air humidity in the room,
●
use widely available antistatic agents.
Design
A
1 Outlet filter cover
2 Fastening of the nozzle brush or the telescopic pipe
3 Plug with the cord
4 ON/OFF button
5 Suction power regulation control
6 Knob backlight (blue) (ZVC431HP) / safety valve indicator
7 Cord winder button
8 CYKLON dust container release button
VACUUM CLEANER TYPES
Workmanship
and equipment
option
Adjustable suction power
Safety valve
Knob backlight
Dust container
Inlet filter
Outlet filter
Suction hose
Suction tube
Switch-over nozzle brush
Small nozzle
Crevice nozzle
Small brush
BNB floor brush
1 2 3 4 5 6 7 8 9 10 11 12 13 14
ZVC431HP
+ + +
CYKLON HEPA H13 HEPA H13 CBS Telescopic
+ + + + +
ZVC431SK
+ + –
CYKLON EPA E10 HEPA H13 CBS Telescopic
+ + + + –