Humphrey Matrix User Manual
2660021138935 Rev. F 2015-11
Patient Testing
5-13
“There is a brief flash just before the actual test begins.” [select Start Test button.] “The test
is beginning now. Please remember to keep looking at the black spot in the center of the
screen at all times during the test.”
It is a good idea to encourage the patient throughout the testing to help ensure proper
patient alignment, fixation, and attention. Remind the patient to occasionally blink.
Testing
Once the test preparations are complete and the patient is ready to begin:
1. Select the Start Test button located on the lower left of the T
ESTING
Screen to begin the
test.
2. If the Patient Visor is not in the correct position for the test selected, the Patient
Response button is not connected properly, there is too much ambient light, or
calibration is needed, an error message will appear when the Start Test button is
selected.
Once the test starts there is a test progress bar indicating “Testing…” below the chart
display on the right side of the screen. The tested visual field location is indicated on the
chart display throughout the test. There are also two buttons on the lower left of the screen
to control the test:
Pause: Selecting this button pauses the test. When paused the progress bar will say,
“Paused…” and the Pause button changes to Resume Test. Pressing the Resume Test
button will resume the test.
Cancel: Selecting this button will bring up a prompt asking “Are you sure you want to
cancel the test?” Clicking on the No button will resume the test, while clicking on the
Yes button will delete the data collected during that test and bring up four options:
Re-Test Right (Left): Select this button to repeat the test on the same eye.
Test Left (Right) Eye: Select this button to test the opposite eye.
New Test: Select this button to bring up the original T
ESTING
Screen for the same
patient for additional testing.
Done Testing: Selecting this button returns to the M
AIN
M
ENU
.
At any time during the test the patient may press and hold the Response button to pause
the test. The test will resume automatically when the Response button is released.
Once the test for the first eye is complete the instrument will momentarily beep. Choose
one of the three options relative to testing the second eye:
Start Left (Right) Eye: Select this button to perform the same test type on the other
eye.
New Test: Select this button to bring up the original T
ESTING
Screen for the same
patient for additional testing.
Done Testing: Selecting this button returns to the M
AIN
M
ENU
.
Содержание Humphrey Matrix 800
