Zebex Z-3051BT, Руководство пользователя, Страница: 23 / 72

Handheld Bluetooth® CCD/Laser Scanner 15
U
SER
’
S
M
ANUAL
14. Test scan any barcode, and all scanned data should show in your screw.
Figure 3-10
15. If the scanner LED flashes in GREEN light indicating it is off-line, or out of range.
Trigger the scan button or move in of communication range to be on-line again.
SPP - Master
In this section, the scanner is configured as SPP-Master, and a pair barcode must be
created to the remote Bluetooth® device to which the scanner can connect.
The 12 digits Bluetooth® address of the remote device and its PIN code must be obtained
before start pairing. Such address and PIN code can be found in its manual. Follow the
steps below to start pairing.
1.
Power on the remote device and have its address ready in hand.
2.
Scan the “Start of Configuration” barcode label to enter programming mode.
3.
Scan “SPP Master” barcode label.
4.
Scan “Set Bluetooth® Address” barcode label.
5.
Scan from the ASCII table (page 62) to enter these 12 digit address. E.g. the
Bluetooth® address is “011B1345600”, scan the “0”, “0”, “1”, “1”, “B”, “1”, “3”, “4”, “5”,
“6”, “0”, “0” from ASCII barcode labels.