Zebex Z-3051BT, Руководство пользователя

Страница: 18 / 72

Handheld Bluetooth® CCD/Laser Scanner 10
U
SER
’
S
M
ANUAL
Pairing Scanner and Cradle Host
This scanner supports three radio communication types,

Cradle Host,

SPP (Serial Protocol Profile) Slave

SPP (Serial Protocol Profile) Master.
Cradle Host
The scanner and communication cradle in the same delivery box are paired in factory, as
soon as both are powered on, it should find and connect to each other immediately.
However, in any circumstance that scanner and cradle are not paired with the cradle,
follow steps below to redo pairing.
1.
Follow procedures in Section 2.2 to connect the cradle and charging the scanner.
2.
Power on the cradle and it should light in RED first than LED flashes “BLUE”, and it is
ready for pairing.
3.
Place the scanner into cradle until a short beep heard to confirm position correctly.
4.
Hold down simultaneously the two buttons at the side of cradle LED lamp (shown as
Figure 3-1) for over 2 seconds.
Figure 3-1
The cradle LED lights in RED and the scanner beeps as a High-Low-High beep tone,
and then the scanner and cradle both LED flashes. If pairing is success, you will
hear Low-High beep tone and cradle LED stays in BLUE and scanner LED stays in
GREEN.
5.
If the cradle is locked for pairing, or if scanner is not set in cradle host mode, it beeps
twice and GREEN LED on scanner puts out.