Technical Note “Complete Guide to Monitoring the Azzurro ZCS Systems via Wi-Fi”
-
Rev. 1.2 of 20/05/2019
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
www.zcsazzurro.com
Page
26
of
38
If one of the above three conditions is not met, the configuration process has not been
successful, maybe because the wrong router password was entered or the device was
disconnected during connection.
Figure 38 – Status screen
However, if all these conditions have been met, the Wi-Fi card of the inverter has been
correctly configured and is ready to monitor the system.
6)
If at the end of the previous checks and subsequent configuration, the Remote server A is still
configured to “Unpingable”, then it is very likely that there is a problem of transmission with the
home network and, in particular, that the data between the Wi-Fi card and the server is not being
transmitted correctly. In this case, it is advisable to carry out checks at the router level in order to
ensure that there are no obstructions on the output of data packets to our server.
To make sure that the problems lies in the home router and to exclude problems with the Wi-Fi card,
configure the card by using the Wi-Fi hotspot function on your smartphone as a reference Wi-Fi
network and not your home wireless network.
Using an Android mobile phone as a modem
a)
Check that the 3G/LTE connection is active on your smartphone. Go to the Settings menu of the
operating system (the gears icon on the screen with a list of all the apps installed on the phone),
select “Other” from the Wireless and Networks menu and make sure Network Type is set to
3G/4G
