Technical Note “Complete Guide to Monitoring the Azzurro ZCS Systems via Wi-Fi”
-
Rev. 1.2 of 20/05/2019
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
www.zcsazzurro.com
Page
5
of
38
Figure 3 – Opening of the hooks on the seat of the flat connector
5)
Insert the Wi-Fi card into the dedicated slot on the communication board, also marked by an outline
of the card, as show in the following image.
Figure 4 – Location of the Wi-Fi card on the communication card
Make sure to first insert the two plastic connectors in the slots positioned at the top, and then match the
pins of the Wi-Fi card to the bottom slots. Press the card lightly to make sure it is mounted properly.
6)
Pass the antenna connected to the card through the cable gland on the bottom of the inverter, after
loosening the ring nut and removing the rubber stopper inside; finally, make sure the antenna is
stable by rotating the ring nut in the opposite direction.
If during this operation, the cable connected to the antenna detaches from the card, connect it again
by placing the two connectors on top, and exerting a slight pressure, as shown in the following image.
