ZBE CHROMIRA, Руководство пользователя

Страница: 68 / 93

Chromira 68
4. Once the Strip is inserted through the Linear Encoder body, slide the head to
the right a little, keeping the strip in place (slide the strip through the Encoder
body at the same time), to gain access to the screws that hold the left end of
the strip in place.
5. Insert the left end of the strip into the clamp that held the old one. The end of
the Strip should protrude from underneath the far side of the clamp by about
1/8 - 3/8 inch (3-9mm). Once in position, tighten the two screws moderately to
hold the end in place.
6. Slide the head nearly all the way to the right, but leave the right end clamp in
sight.
7. The right end of the Strip should now be sitting near the proper location at the
right end clamp.
8. Replace the clamp cover and the two screws that hold it in place (removed in
Step #3). Some of the strip will be sticking out from the far side of this clamp.
This is normal.
9. Tighten these two screws moderately to hold this end in place.
10. With the Linear Encoder Strip temporarily held in place, you can now align it.
11. At the left end of the Strip, tighten the two tensioning screws about two (2)
turns each. These screws are marked “C” in the drawing on the preceding
page. This will make the encoder strip taut between the two clamps.
12. With the head near the right end of the rail, look at the Encoder Strip’s position
in the Encoder Body slot. It should be centered top to bottom. If it is not,
loosen the screws on
the right end clamp, and grasp the end of the strip that protrudes from the far
side of the clamp (with your fingers or a pair of needle-nose pliers). While
holding the strip tight, position it up or down as needed, and tighten the
screws with your other hand. Double check that the strip’s position in the slot is