ZAGI 400 X ELECTRIC, Инструкция по сборке

Страница: 10 / 22

page 9
Figure 10
Antenna Servo wires
(See Figure 10) Install the antenna along the leading edge seam between the two types of
foam. Cut a 1/4” slot in the seam between the receiver (RX) and the wing tip. Push the
antenna into the slot with a flat blade screwdriver. The antenna will extend several inches
beyond the tip. Before securing the servos in place make sure that the servo arms are in
the correct position. Position the two servos on the table in the proper orientation as they
would be installed on the plane and connect to the receiver. Turn on the transmitter (TX)
and connect a spare 4.8 V battery to the (RX). The TX should be in the elevon or mixing
mode. Check the radio instruction manual for the “Elevon mixing or Delta mixing set-
tings”. Set the trim levers on the TX to zero. Install the servo arms as close to vertical as
you can get. Make sure that both arms move forward when the TX stick is pulled back.
Move the TX stick to the right. The servo arm on the right should move forward as the
one on the left moves back. Reverse the controls in the TX as necessary. Push the ser-
vos into the servo bays. Apply a piece of color tape over the servos to hold them in place.
Alternate receiver location