YZ Systems NJEX ZEO 6400, Инструкция и руководство по эксплуатации

Страница: 37 / 106

SECTION 5: SYSTEM CONTROL ELECTRONICS
YZ Systems Milton Roy • 201 Ivyland Road • Ivyland, PA • USA • 18974 • P: 281.362.6500 • www.yzsystems.com
NJEX ZEO Version 04/13/2021 Page 35
Using the N-400 Home Screen
The N-400 Home Screen displays important information about your NJEX ZEO system and is
used to start, stop, or fill the NJEX ZEO system.
The Home Screen displays eight
information sections with key
information. The upper and lower
display bars, Sections 1 and 2, display
operational
information and
instructions for starting and stopping
the system. The six main blocks of
the home screen, Sections 3-8,
display various operating parameters.
See Figure 18 to reference each
section location.
Section 1 is the upper display bar,
which displays information dependent
on the system settings. In the upper
left corner, an icon will be displayed
as a quick reference for which
operational mode the system is
operating in. The operational modes
are
Proportional-To-Flow or
Proportional-To-Time. See Setting
Operator Input Parameters below on
how to adjust these parameters.
Additional Icons that will display are the Memory Module icon, which notifies the user that the
MM-400 Memory Module is plugged in, properly recognized, and collecting data. The Remote
Inhibit icon will display if the unit is disabled due to a Remote Inhibit input while in the Default
(NBS Output) System Redundancy mode. The load Input icon is displayed when the system has
a load input device wired and is active. The Modbus communication icons will display when there
is an active Modbus connection in either the COM1 or COM2 port respectively.
Table 4: N-400 Home Screen Upper Display Bar Reference Icons
Operational Mode Icon
Memory
Module
Present
Remote
Inhibit
Active
Load
Input
Modbus
Communication
Prop-To-
Time
Prop-To-Flow
(Pulse or
Analog)
COM1 COM2
1
2
3
4
5
6
Figure 18 N-400 Controller Home Screen Section Outlines
7
8