Yukon HLS1500P, Инструкция по сборке, испытанию, эксплуатации, обслуживанию и хранению

Страница: 18 / 20

18
15 tonne Hydraulic Log Splitter Assembly, Installation, Care, Maintenance useage Instruction Manual
10.0 TROUBLESHOOTING
Problem Probable Cause Suggested Remedy
Overload Protection Device
disengaged to protect the log splitter
from being damaged
Log is Not properly positioned
The sizes or hardness of the log
exceeds the capacity of the machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on Max. Pressure Limiting
Screw. Lower max pressure rating
was set.
Motor Stops
Staring
Fails to split
logs
Contact a qualified Electrician for opening the Pushbutton Box to
engage the overload Protection Device inside
Refer to “Log Splitter Operation”section for perfect log loading.
Reduce the log sizes before splitting it on the log splitter
Refer to “Sharpening Wedge”section to sharpen the cutting edge.
Locate leak(s) and contact the dealer
Contact the dealer.
Check oil level for possible oil refilling
Loosen Bleed Screw by some rotations Before operating the log
splitter
Tighten the Bleed Screw up before moving the log splitter
Contact the dealer
Tighten the Oil Drain Bolt with Dipstick
Lack of hydraulic oil and excessive
air in the hydraulic system.
Air sealed in hydraulic system
while operating
Bleed Screw is not tightened
Before moving the log splitter
Hydraulic Control Valve Assembly
and / or seal(s) worn
Oil Drain Bolt with Dipstick is not tight
The log
pusher moves
jerkily, taking
unfamiliar noise
or vibrating a
lot
Oil leaks around
cylinder ram or
from other
points
Yukon