Yuchai U35, Руководство оператора

Страница: 98 / 157

4-29
2. During the storage
1) During storage, the machine should be operated once a month to apply a new oil film to
the surface of the moving parts. At the same time, charge the battery.
2) The air conditioner (if any) on the machine should also be run.
3) Run the track
Warning: If rust prevention operations for machine stored indoors are
necessary, open the doors and windows to improve the air circulation to
prevent gas poisoning.
3. Recovery from storage
Before using a machine that has been stored for a long time, the following steps should be
followed.
1) Wipe off the lubricating grease applied to the surface of the cylinder piston rod.
2) Fill all parts with oil and grease.
3) When the machine is stored for a long time, water in the atmosphere will enter the oil.
Before or after starting the engine, check the oil in all parts. If there is water in the oil, replace
all the oil.
Attention: 1) Under normal climatic conditions, the storage method mentioned earlier
can allow the excavator to be stored for one year. However, after 6 months of storage,
each component should be run for 15 minutes without loading. At the same time,
lubricating oil should also be added to each component.
2) Before putting the excavator that have been stored for a long time back into use,
necessary work and inspections must be carried out. After the excavator has been
stored for one year, the oil in the reducer and hydraulic line also needs to be
replaced.