Yuchai U35, Руководство оператора

Страница: 94 / 157

4-25
3. Securing the machine on the
transport vehicle
1) Well arrange the attachment.
2) Turn off the engine and remove the key
from the start switch.
3) Lift the safety lock lever and the above
control box
4) Lock the cab and engine hood.
5) Place blocks under both ends of the
track to prevent the machine from moving
during transportation, and secure the
machine with wire ropes. Make sure to
secure the machine firmly so that it will not
slide to one side.
4. Unloading from the transport vehicle
1) Truck loading/unloading can only allowed on solid and flat ground, and a certain safe
distance should be maintained from the edge of the road.
2) The transport vehicle is braked, and a pad is placed under the tire to ensure that the
vehicle does not move.
3) Install a ramp between the transportation vehicle and the machine, ensuring that both
sides of the ramp are on the same level. The maximum slope of the ramp shall not exceed
15 degrees. Adjust the space between the ramps to match the center of the track.
4) Remove the wire rope securing the machine.
5) Start the engine. In winter, thoroughly warm up the engine.
6) Put down the safety lock handle.
7) Lift the bucket arm and bucket, and raise the dozer blade.
8) Check that there are no obstacles within the range of excavator activity.
9) Pull out the locking pin of the platform to rotate it 180 degrees, with the excavation device
facing the slope and the excavator in the forward direction.
10) Drive the excavator slowly forward until it reaches the top of the landing plate, extend the
bucket arm outward, cause the excavator track to tilt down onto the slope, and then slowly
advance until it reaches the ground.