Yuchai U35, Руководство оператора

Страница: 93 / 157

4-24
2. Truck loading
1) Truck loading can only allowed on solid and
flat ground, and a certain safe distance should
be maintained from the edge of the road.
2) Appropriately apply brakes to the transport
vehicle, and put a pad under the tire to
ensure that the transport vehicle does not
move.
3) Install a ramp between the transportation
vehicle and the machine, ensuring that both
sides of the ramp are on the same level. The
maximum slope of the ramp shall not exceed
15 degrees. Adjust the space between the
ramps to match the center of the track.
4) Align the excavator with the slab ramp,
with the bulldozer at the rear. For safety
reasons, the excavator should be approach
and slowly climb up the ramp until the end of
the slope.
Attention: When on a ramp, only the
travel joystick can be operated. Do not
operate any other joystick or pedal.
5) Stop driving and extend the stick (position
B in the figure), so that the front part of the
excavator track is tilted down to the bottom
plate of the transport vehicle. Be careful not
to let the working device touch the body of
the transport vehicle when the machine is
tilted down. Continue driving the machine to
the designated position on the transport
vehicle.
6) Put down the stick, drop the bucket on the
floor, put down the bulldozer, and park the
machine at the specified position on the
transport vehicle.
Before the work or operation is completed, the driver should first pull up
the safety lock/lever to lift the left control box to cut off the source of the
pilot control oil line and avoid misoperation of the machine due to errors
or unintentional touch with the joystick.
Attention: Please choose a transport vehicle that matches the weight and
dimensions provided in this manual.
Ramp
Pad block
Pad block
Up to 15°
Space
between the
ramps
<15°