www.youfibercable.com
Email:[email protected] MSN:[email protected]
11
Figure 5
3>
Put down fiber holder and windshield to finish loading. Then figure 7 should be
displayed on screen. The distance between two fibers must less than radius of
fiber. If the distance exceed adjust arrange, KL-280 doesn’t splice, then you should
load fiber over again and clean V-groove. (Consult 10.4)
2R
LCD monitor
<R
Figure 6
(fiber of X axis and Y axis)
6.3.3
Fusion instance and measure
Table 2 is the possible phenomena that appeared after pressing “RUN” or
“TEST”.
If the phenomena don’t exist, please consult <Addenda A>.
☆
Notice: 1> To guarantee fusion target, please setting value of “Setting end-surface”
about 6.
2>Make sure that electrode is fixed well before splicing.
3>Make sure that electrode is well and there’s no obvious injury on electrode’s
top.
4>Best to test arc each time before splicing.2 times.