《目次》 《索引》
TI 71M01D03-03
1st Edition : 2007.03.12-00
Introduction
It is necessary to tune the servo settings and positioning control after the
motor and drive are installed (mounted).
This manual is the simplified instruction to set the servo tuning and
positioning control using “DrvX3 Support Tool”, the free software that can be
down-loaded from Yokogawa Website.
Follow the below instructions after installing the software into your PC.
This manual describes the start-up process from the factory default settings.
Refer to #Q3 of “Q&A” in the Appendix.
For further details, refer to the Technical Information.
Device configuration when tuning
Symbols in this maual
i
Warning
Warning to avoid unexpected system trouble or hardware
damage
Detail is described in the “Glossary” in the Appendix.
Refer to the glossary if needed.
Notice to lean about operation method and functions
The following symbols are used in this manual in accordance with the contents.
Notice
Power cable
Motor and load
DrvGIII
Computor
RS232C cable
Encoder cable
PLC
Controller
!
Caution
Caution to avoid dangers in case there is a danger which may
do on human lives and health, such as electric shock
