3-4
IM AQ6380-02EN
3.1 Installing the Instrument
Rack Mounting
To rack-mount the instrument, use the separately sold rack mount kit.
Product Name
Model
Rack Mounting Kit for EIA Single
751535-E5
Rack Mounting Kit for JIS Single
751535-J5
An outline of the mounting procedure is given below. For detailed instructions, see the manual that
is included with the rack mount kit.
1.
Remove the handles from both sides of the instrument.
2.
Remove the four feet from the bottom of the instrument.
3.
Remove the four seals the rack mount attachment holes on each side of the instrument near
the front.
4.
Place seals over the feet and handle attachment holes.
5.
Attach the rack mount kit to the instrument.
6.
Mount the instrument on a rack.
Note
• When rack-mounting the instrument, allow at least 10 cm of space around the inlet and exhaust holes to
prevent internal heating.
• Make sure to provide adequate support from the bottom of the instrument. The support should not block
the inlet and exhaust holes.
Do Not Install the Instrument in the Following Places
• Outdoors.
• Dangerous locations where flammable or explosive gasses, vapors, or dust is present, or where
the possibility of explosions or fires exists.
• In direct sunlight or near heat sources.
• Where an excessive amount of soot, steam, dust, or corrosive gas is present.
• Location where mechanical vibration is high.
• In an unstable place.
• Where the instrument is exposed to water or other liquids.
