YILMAZ PCC 6505, Руководство пользователя

Страница: 46 / 87

46

When 90 degrees is achieved, press on button to confirm the process.
7.6.6 Calibration of 135 Degrees

Enter 135 in section and press on send button

Place 135 degrees calibration apparatus between miter and saw as shown in below figure.

If angle is bigger than 135 degrees, enter a smaller value than 135
degrees to target section and press on send button. If it is smaller than 135 degrees, enter a bigger value than 135 degrees
to target section.

When 135 degrees is achieved, press on button to confirm the process
7.6.7 Calibration of Profile Holding Robot on Y- Axis

Before starting calibration of profile holding robot, define the reference of in Y- axis.

Calibration of robot is performed by using the below screen.

Enter the maximum allowable distance of robot on Y- axis in the below section.

While robot is at reference position on Y- axis, measure the distance between zero point of profile along Y- axis and inside
the claw as shown in below figure.