Yetter 5000-005B, Руководство оператора

Страница: 34 / 40

34
5000-031C ASSEMBLY INSTRUCTIONS / PART ID
FANTINI 8 ROW
Step 1: Attach each 5000-258 mount bracket
to the frame using 4) 5/8” X 7” bolts, 2) 5000-386 mount straps, 4) 5/8” flat washers
(underneath mount plate),
& 4) 5/8” lock hex nuts. Mounting brackets should be located between rows 1 & 2, 2 & 3, 3 & 4, 5 & 6,
6 & 7, and 7 & 8. Install the 5000-323 lock up pin in the storage location & secure each in place with 2) 7 gauge cotter hairpin.
Step 2: Install 1) 5000-318 pivot bushing in each single mount. Attach 1) 5000-256 LH over bearing arm to the single mount
between rows 2 & 3, 3 & 4, and 7 & 8. Install 1) 5000-259 RH over bearing arm to the single mount between rows 1 & 2, 5 & 6,
and 6 & 7. Align the lower hole on each arm with the pivot bushing &
insert a 5/8” X 3” bolt through & fasten with a 5/8” lock nut.
Step 3: Install 1) 2570-
126 ¾” X 10” eyebolt to each single mount. Attach each over bearing arm to each eyebolt using 1) 2510-
121 5/8” diameter shoulder bolt, 2) 2526-449 5/8” flat washers, & 1) 2520-364 ½” jam lock nut. The 5/8” flat washers go on each
side of the eyebolt & inside the arm channel. The shoulder bolt should be inserted through the top hole on each arm. Only tighten
the ½” jam lock nut until it makes slight contact with the over bearing arm.
Step 4: Install the 2550-709 compression spring over each eyebolt, place the 2975-302 spring bushing over the eyebolt & onto
the compression spring, & secure with the 2520-
511 ¾” lock nut. Tighten the lock nut to be flush with the end of the eyebolt.
Step 5: Install each 3 row roller mount. For rows 1
– 3, slide the roller mount into place between the clamp plates on the over
bearing arm between rows 1 & 2 and 2 & 3. Repeat this process to attach the roller mount for rows 6
– 8 using the over bearing
arms between rows 6 & 7 and 7 & 8. Install the 2 row roller mount by sliding the roller mount into place between the clamp plates
on the arm between rows 3 & 4 and 5 & 6. The bearing mount tab will be centered in the cut-out of each clamp plate. Use 2)
5000-378 spacer bushings, 2
) ½” X 3 ¾” bolts, & 2) ½” lock nuts to attach the roller mount tube to each arm clamp. Do not
tighten each roller mount into place until after the roller is installed so you can center the roller if needed. Make sure the bearing
support is on the back side of the roller mount tab.
Step 6: Attach each roller to the roller mount & the 5000-203B 2 row roller to the 2 row roller mount using 2) 5000-322 shim
washers, 2) 5000-
355 bearing assemblies, 6) ½” X 2 ½” bolts, & 6) ½” lock nuts per roller.
NOTE: BEARING HOUSING SHOULD BE LUBRICATED WITH POLYUREA GREASE BEFORE USE AND THEN EVERY 100 HOURS OF OPERATION