Yetter 5000-005B, Руководство оператора

Страница: 26 / 40

26
5000-017D ASSEMBLY INSTRUCTIONS / PART ID
DRAGO 830 ROW
Step 1: Attach each 5000-218 Drago mount brackets to t
he frame using 2) 5/8” X 3” bolts & 2) 5000-340 clamp blocks for the
bottom set of holes & 2) ½” X 2 bolts, 2) 5000-339 mount plate washers, & 2) ½” hex flange lock nuts for the top set of holes.
Mounting brackets should be located between rows 1 & 2, 2 & 3, 3 & 4, 5 & 6, 6 & 7, and 7 & 8. Install the 5000-323 lock up pin
in the storage location & secure each in place with 2) 7 gauge cotter hairpin.
Step 2: Install 1) 5000-318 pivot bushing in each mount. Attach 1) 5000-259 RH over bearing arm to each mount between rows 1
& 2 and 6 & 7. Attach 1) 5000-256 LH over bearing arm to each mount between rows 2 & 3 and 7 & 8. Install the 5000-241 wide
centered fixed pivot arm to the mount between rows 3 & 4 and 5 & 6. Align the lower hole on each arm with the pivot bushing and
insert a 5/8” X 3” bolt through & fasten with a 5/8” lock nut.
Step 3: Install 1) 2570-
126 ¾” X 10” eyebolt to each mount. Attach each over bearing arm to the eyebolt using 1) 2510-121 5/8”
diameter shoulder bolt, 2) 2526-
449 5/8” flat washers, & 1) 2520-364 ½” jam lock nut. The 5/8” flat washers go on each side of the
eyebolt & inside the arm channel. The shoulder bolt should be inserted through the top hole on each arm.
Only tighten the ½” jam
lock nut until it makes slight contact with the over bearing arm.
Step 4: Install the 2550-709 compression spring over each eyebolt, place the 2975-302 spring bushing over the eyebolt & onto the
compression spring, & secure with the 2520-
511 ¾” lock nut. Tighten the lock nut to be flush with the end of the eyebolt.
Step 5: Install each 3 row roller mount. For rows 1
– 3, slide the roller mount into place between the plates on the over bearing
arm between rows 1 & 2 and 2 & 3. Use 2) 5000-378 spacer bushings, 2
) ½” X 3 ¾” bolts, & 2) ½” lock nuts to attach the roller
mount tube to each arm clamp. Repeat this process to attach the roller mount for rows 6
– 8 using the over bearing arm between
rows 6 & 7 and 7 & 8. Do not tighten each roller mount into place until after the roller is installed so you can center the roller if
needed. Make sure the bearing support is on the back side of the roller mount tab.
Step 6: Attach each roller to the roller mount using 2) 5000-322 shim washers, 2) 5000-355 bearing
assemblies, 6) ½” X 2 ½” bolts, & 6) ½” lock nuts per roller.
NOTE: BEARING HOUSING SHOULD BE LUBRICATED WITH POLYUREA GREASE BEFORE USE AND THEN EVERY 100 HOURS OF OPERATION