Yeswelder YWM-211P, Руководство оператора

Страница: 15 / 40

Installing The MIG Gun Assembly
Gas Cylinder And Regulator Connection
The gas cylinder (not supplied) should be located near the rear of the welder, in a well-ventilated area and securely fixed to
the work bench or to the wall to ensure that it will not fall.
For safety and economy, ensure that the regulator is fully closed (turned counter-clockwise) when not welding and when
fitting or removing the gas cylinder.
Ÿ Turn the regulator adjustment knob counter-clockwise to ensure the valve is fully closed.
Ÿ
Screw the gas regulator down on the gas bottle valve and tighten.
Ÿ Connect the gas hose to the regulator, securing with the clip/nut provided.
Ÿ
Connect the other end to the GAS Inlet (16) on the back of the machine.
Ÿ
Open the cylinder valve, then set the gas flow to approximately 20-30 CFH (cubic ft. per hour) on the regulator.
Ÿ For MIG welding: Pull the gun trigger to ensure the shielding gas flows through the gun.
Installing The Welding Wire
ENSURE GAS AND ELECTRICAL SUPPLIES ARE DISCONNECTED. Before proceeding, remove the nozzle and the
contact tip from the gun.
WARNING: ELECTRIC SHOCK CAN KILL! Always turn the Power SWITCH OFF and unplug the welder’s INPUT POWER
CABLE from the AC power source before installing wire. When the gun trigger is depressed, the drive rolls, spool of wire,
wire being fed, and electrode are all electrically live (hot).
8"
4"
A
C E DE B C E D E
I
H
J
G
K L M
2-inch Spindle
Adapter (For 8" Reel of Wire)
WARNING: Cylinders are highly pressurized. Handle with care. Serious accidents can result from improper handling or
misuse of compressed gas cylinders. Please do not drop the cylinder, knock it over, and expose it to excessive heat,
flames, or sparks. Do not strike it against other cylinders or strike an arc on it.
- 11 -
Ÿ Attach the standard MIG welding gun to the EURO CONNECT on the front of the welder. Ensure the gun connector end is seated
fully into the wire drive and tighten the thumbscrew to secure the gun.