Yeswelder YWM-211P, Руководство оператора

Страница: 25 / 40

(1) Lay the gun straight on the ground and remove consumables on the front-end parts.
(2) Remove the liner retaining nut.
(3) Pull the steel wire feed liner out of the gun cable assembly.
(4) Unravel the graphene wire feed liner and feed the liner in short forward movements down the cable assembly all the way through
and out the torch end. Avoid kinking the liner. Kinking the liner will damage it and require replacement.
(5) Leaving the liner extending out the end of the torch end by 1/8".
(6) Place the tip holder over the end of the liner and, screw it into the torch neck, tighten it up. Reassemble the consumables with a
special aluminum A+ contact tip, nozzle, and gas diffuser.
(7) Fit the liner collet, O-ring, and liner retaining nut.
(8) Push the liner firmly into the torch lead and tighten the liner retaining nut.
(9) Cut the liner flush with the end of the liner retaining nut using a sharp box cutter knife.
(10) Disengage the drive roller.
(11) Loosen off the outlet guide tube retaining screw.
(12) Remove the outlet guide tube from the front-end euro connector using long nose pliers.
(13) Feed the extended graphene liner section into the outlet guide tube hole of the machine Euro connector.
(14) Feed the extended graphene liner up and over the drive roller.
(15) Tighten the torch Euro connection to the machine Euro connector.
(16) Cut the extended liner with a sharp knife.
(17) Install the correct sized U Knurled Drive roller, and feed the correct diameter of aluminum welding wire.
(18) Install a matched contact tip and other front-end accessories to the torch. It is ready for welding.
(19) Set the welding parameters via Synergic MIG or Manual MIG.
Set up for Aluminum Welding With MIG Gun With Graphene Liner
- 21-
Ÿ
Install optional YesWelder LBT150 spool
gun into Euro MIG torch connection
socket on the front panel, and tighten it.
Connect the Spool Gun control cable to
the receptacle and tighten it.
Ÿ
Push the Cover Release clip on the
spool gun to unlock the wire housing
cover.
Ÿ
Place the wire on the spool holder, tak-
ing care to put the parts back on cor-
rectly. (Note: the tensioner part need to
remove first and remember to fit back.)
Ÿ Place the spool of welding wire on the
spool holder, correctly putting the parts
back on. (Note: the tensioner part needs
to remove first, and remember to put it
back.) Ÿ Adjust the spool holder’s tension to en-
able a smooth and stable wire feeding. Ÿ Remove the gas nozzle and contact tip
from the welding torch.
Ÿ
Install a correct-sized contact tip, screw
the contact tip into the tip holder of the
torch, and tighten it up.
Ÿ
Turn the power source on and select the
Manual MIG function with the MIG/Pulse
MIG/Lift TIG/Stick selector switch with
Syn off.
Ÿ
Set gun selector toggle switch to Spool
Gun inside the wire feeding door.