YATO YT-85120, Оригинальное руководство пользователя

Страница: 18 / 82

18
GB
O R I G I N A L I N S T R U C T I O N S
Do not stand in the cutting plane. This will reduce the risk of injury when the pole pruner rebounds (XII)
Always, during working, you should hold the pole pruner with both hands.
Make sure, the chain is always sharpened and properly tight.
When cutting branches and boughs you should not cut them close to the trunk, but first at a distance of about 15 cm from the trunk.
You should make two incisions on the depth equal to 1/3 the branch diameter about 8 cm apart. One incision from the bottom, the
second from the top. Then cut a branch right next to the trunk to a depth equal to 1/3 the diameter of the branch. Finish cutting by
cutting the branch next to the trunk from the top. It is forbidden to cut branches by cutting them upwards (XIII).
In the case when the pole pruner is wedged during cutting the trunk, you should never left it with running engine in this position.
You should switch off the tool motor, disconnect it from its power supply and remove the pole pruner from the trunk by using
wedges.
It is forbidden to use of the pole pruner to hedge forming or cutting of shrubs.
Do not touch ground by the cutting head, chain and guide, do not allow for contamination of the tool by soil.
MAINTENANCE AND STORAGE OF THE PRODUCT
Attention! Before starting any operation, which is described below, you should disconnect the pole pruner from the power supply.
The tool, which is mains powered, should be disconnected from the wall outlet, the tool, which are battery operated, should be
disconnect from the battery.
After each use, you should examine your tool condition with particular emphasis on the patency of the ventilation openings.
Check the alignment of all elements of the tool. Any loose connections should be tightened. Check the voltage and condition of
the chain. If you notice any chain damage, the chain should be replaced with a new one. It is forbidden to operate the pole pruner
with a damaged chain!
Too loose chain may fall out from its guide, which can cause injuries to the operator. The chain must also be properly sharpened,
because it requires the relevant experience and tools, it is recommended, to perform chain sharpening in a specialist service. You
should fill up the oil deficiencies in the tank. The tool housing should be cleaned with a soft dry cloth. Clean the housing of residual
wood, oil, grease and other contaminants. The tool should be stored in a dry, closed room, disconnected from the mains.
Attention! During the tool storage, it can produce a small amount of oil from the chain lubrication system, this is normal and does
not affect the oil level in the tank and is not a sign of failure.
The tool should be stored in the areas, which are shaded, dry, and equipped with adequate ventilation to prevent condensation.
The place should not be available for bystanders, especially children. During storage the guide and chain should always be
protected by the cover.