1-7
SA221/324/424 Operation Manual
1. Disengagement of the 4-wheel drive is
recommended.
2. Remember that the braking characteristics differ
between the 2-wheel drive and 4-wheel drive
modes. Be aware of the current drive mode and
use carefully.
3. Before turning, always slow down the tractor.
High speed turn may cause the tractor to tip over.
4. When traveling on a road, ensure that the Slow
Moving Vehicle (SMV) emblem is on the rear of
tractor and is clearly visible. Use the hazard lights
and turn signal lights as required by the currently
effective local laws or regulations.
5. Strictly observe all the currently effective local
traffic and safety laws and regulations.
6. Turn ON the headlights as required by the
currently effective local laws or regulations.
7. Always travel at a speed that allows the operator
to maintain control of the tractor.
8. While traveling on a road, do not turn the steering
wheel suddenly. Such an action can lead to loss
in the stability of the tractor and can cause an
extremely dangerous situation.
9. While on a road, do not attempt to operate an
implement. During transportation, place the 3-
point hitch control lever in the raised position and
lock the 3-point hitch control lever with the
position stop knob. Do not fully close the
hydraulic flow control/stop knob to hold an
implement in the raised position while the tractor
is traveling with the implements. The preceding
action can cause damage to the hydraulic lift
circuit.
10. Use safety lights and devices at night because
slow moving tractors on public road are hard to
see.
1. Push down Power Take Off (PTO) switch to OFF
position, lower the implements to the ground,
move the range shift lever to N (neutral) position,
engage the parking brake securely, for details,
see "6. Lock and Set the Parking Brake" on page
7-3, shut off the engine and remove the key.
2. Before leaving the tractor, ensure that the tractor
is completely stopped.
3. Avoid parking the tractor on a steep slope.
Rather, park on solid and level ground whenever
possible. If parking on a slope is unavoidable,
park the tractor across the slope and lower the
implement to the ground and chock all the tires
safely and securely.
1. Before connecting/disconnecting, adjusting,
cleaning or servicing Power Take Off (PTO)
driven implement, ensure that all the moving
components are not moving.
2. Make sure that Power Take Off (PTO) shaft cap
is always in place. Replace Power Take Off
(PTO) shaft cap only when the shaft is not
moving.
3. Before installing or operating the Power Take Off
(PTO) driven implement, carefully study the
Operation Manual
of the implement and the
safety decals on the implement.
4. When installing stationary Power Take Off (PTO)
driven implements, ensure to engage the parking
brake securely, for details, see "6. Lock and Set
the Parking Brake" on page 7-3, chock all the
tires safely and securely. Avoid approaching or
accessing any rotating component.
6. Travel on a Road
7. Safe Practices for Parking the Tractor
8. Operate the Power Take Off (PTO)
SA221_324_424_OperatorsManual.book 7 ページ ２０１８年６月４日 月曜日 午後５時１９分
