15. SERVICE THE ELECTRICAL SYSTEM
SA221/324/424 Operation Manual
6. Remove the two screws and lens from the tail
lights housing.
7. Push down and rotate the tail lights bulb
counterclockwise to remove the tail lights bulb.
8. Push the new tail lights bulb into the socket and
rotate tail lights bulb clockwise to lock position.
9. Turn the starter key switch to ON position.
10.Turn on tail lights switch.
11.Make sure the tail lights bulbs are functioning.
12.Install the lens and screws.
(A) Screw
(B) Lens
(C) Tail lights bulb
■
Replace the Turn Signal/Hazard Lights
Bulb
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
5. Remove the key.
6. Insert a flat screw driver into the slot at the side of
the lens and turn slowly to remove the lens.
• Perform the preceding procedure to the other
lens.
(A) Lens
(B) Bulb
7. Push the turn signal/hazard lights bulb down and
rotate to remove.
8. Insert the new turn signal/hazard lights bulb into
the socket and rotate to lock position.
9. Turn the starter key switch to ON position.
10.Turn on turn signal/hazard lights switch.
11.Make sure the turn signal/hazard lights are
functioning.
12.Install the lenses.
NOTE
●
Service the turn signal/hazard lights, after
removing the front or rear lenses.
(A)
(C)
(B)
(A)
(B)
SA221_324_424_OperatorsManual.book 7 ページ ２０１８年６月４日 月曜日 午後５時１９分
