Yanmar 1GM10, Руководство по ремонту

Страница: 56 / 240

50 CHAPTER THREE
Alternator drive belt replacement (all models)
1. Loosen the alternator retaining nuts
(B, Figure 12).
2. Move the alternator inward sufficiently to allow re-
moval of the belt from the pulleys and remove the belt.
3. Clean the pulley grooves so they are dry and free of
rust or other corrosion.
4. Place the new belt in the pulley grooves.
5. Adjust belt tension as previously described.
Seawater pump drive belt replacement
and models)
1. Remove the alternator drive belt as described in the
previous section.
2. Loosen the screws that secure the seawater pump
mounting plate (B, Figure 14).
3. Move the alternator inward sufficiently to allow re-
moval of the belt from the pulleys and remove the belt.
4. Clean the pulley grooves so they are dry and free of
rust or other corrosion.
5. Place the new belt in the pulley grooves.
6.
Adjust belt tension as previously described.
Crankcase Breather
The crankcase breather assembly vents crankcase
pressure into the intake port or manifold. This produces a
negative pressure in the crankcase. If the breather mal-
functions, oil may be forced past the piston rings, oil seals
and gaskets.
Periodic maintenance is not normally required unless
excessive oil gasses clog the crankcase breather. This is
usually indicated by blue exhaust smoke or oil in the in-
take port or manifold. If the breather must be cleaned fre-
quently, determine the cause, such as broken or stuck
piston rings.
I
Intake port
To Intake
hole
Def
Mesh
hose
Refer to Chapter Five or Six for service procedures for
the crankcase breather. Refer to the following paragraphs
for a description of the breather on specific models.
On and models, a reed valve system lo-
cated on the rocker arm cover controls crankcase gas
movement. See Figure
15. The reed valve opens when the
downward moving piston increases crankcase gas