Yanmar 1GM10, Руководство по ремонту

Страница: 218 / 240

212
CHAPTER TEN
1. Install the input shaft assembly in the transmission
case.
2.
Position the transmission case so the open end is up.
3. Install the outer bearing race on the input shaft tapered
bearing.
4. Measure the distance (A, Figure 30) in millimeters
from the mounting flange mating surface on the case to
the top of the bearing race. Record the measurement.
5. Measure the distance (B, Figure 31) from the mount-
ing flange mating surface to the bottom of the bearing race
bore for the input shaft bearing.
6. Subtract the A measurement from the B measurement.
7. From the result obtained in Step 6, subtract 0.0-0.05
mm. This result equals the thickness of the
that
must be installed in the bearing bore in the mounting
flange.
8. Install the
in the bearing bore in the mounting
flange, then press the bearing outer race into the mounting
flange on top of the shims. Be sure the race is bottomed.
Output Shaft
In the following procedure to adjust bearing preload,
the neutral position of the clutch cone must be established
for proper transmission operation. The desired clutch
cone groove centerline on Model
is 48.3 mm from
the mating surface of the transmission case. On Model
the desired clutch groove centerline is 47.3 mm
from the mating surface of the transmission case.
NOTE
To perform the following bearing
mentprocedure, the output
must be out
of the case and the outer bearing races must
be on the bearings and not installed in the
case or mountingflange.
1. Measure and record the distance (A, Figure 32) from
the mounting flange mating surface to the bottom of the
bearing race bore for the output shaft bearing.
2. Measure and record the distance (B, Figure 33) from
the mounting surface of the case to the bottom of the bear-
ing race bore for the output shaft bearing.
3. Measure and record the distance
(C, Figure 34) from
the faces of the output shaft bearing races.
NOTE
In Steps 4 and 5, force the gears toward the
cone clutch.
4. Measure and record the distance (D, Figure 34) be-
tween the faces of the forward and reverse gears.
5. Measure and record the distance
(E, Figure 34) from
the face of the reverse gear and the face of the rear bearing
race.
6A. On transmissions-To determine rear shim
thickness (Figure proceed as follows:
a. Subtract 48.3 mm from measurement (B, Figure
33).
b. Divide measurement (D, Figure 34) by 2.
c. Subtract
b from a.
d. Subtract measurement (E, Figure 34) from
C.
e. Subtract 0.0-0.05 mm from d. The result is
the required rear shim thickness.
6B. On transmissions-To determine rear shim
thickness (Figure proceed as follows: